68
NICE - MIRIAM - CRISTAL - PRETTY - DIANA - KRISS - MARY
EN
10.7
AIR REGULATOR
The stove is provided with a back air regulator and must have the following parameters (written also on the
back of the stove):
Fig. 22 - Air regulator
• Air regulator entrance 12 mm to nominal power with a chimney flue of 11 Pa.
10.8
FAILED IGNITION
If the pellets do not burn, the failed ignition will be indicated by the alarm “FAILED IGNITION”.
• If the room temperature is lower than 10°C, the plug is not able to bear the ignition stage. To support
it please insert some pellets in the burning pot and a piece of burning firelighter igniter material on the
pellets (for example firelighters cubes).
After a failed ignition the burning pot must be empty from the amassed pellets, before
starting the stove up again.
• Too much pellets in the burning pot, or humid pellet, or sooty burning pot make ignition difficult and
create dense white smoke which is harmful to health and can cause explosions on the combustion
chamber. It is therefore necessary not to stand in front of the stove during ignition stage if dense white
smoke is present.
If after some months the flame appears weak and/or orange colored or the glass tends
to blackens and the burning pot to become encrusted, clean the stove, clean the
fume conduit and the chimney flue.
10.9
POWER FAILURE
• After a black-out lower than 5 seconds, the stove turns back to the power which was settled.
• After a black-out of more than 5 seconds, the stove enters the “COOLING WAIT” phase. Completed this
phase, it starts automatically up with the different phases (see
START UP a pag. 67
).
10.10
TEMPERATURE SETTING
• To modify the ambient temperature it is sufficient to press P1 and P2 keys according to the desired
temperature inside the menu “SET TEMP ROOM”.
• To see the set temperature, press once P1 key.
10.11
FUME TEMPERATURE
To check the fume temperature at the exhaust it is sufficient to keep pressed P2 key.
